亚帆中心工程环抱形防波堤掩护效果及护面块体稳定性试验研究

针对工程环抱形防波堤平面布置方案,利用整体物理模型试验手段进行了验证。结果表明:1)掩护后传入港内波峰线发生了偏转和波能集中,致使码头局部泊稳条件不满足标准要求。将位轴线顺时针旋转15°,与波峰线平行优化布置后,则满足。2)根据越堤波浪是否冲击港内码头轴线标准,论证10.0、10.5、11.0 m共3个防波提高程掩护体,得出11.0 m是可行的。3)防波堤外侧质量6 t护面块体失稳,经多次优化后采用质量10 t则稳定,弧形转弯处勾连性护面块体受侧向波浪力作用比受正向波浪力偏于危险。4)将试验结果与规范公式计算值进行对比,前者均大,因此对于弧形转弯段的处理应给予关注,尽量遵循规范要求轴线夹角的相关规定。5)试验再次验证了三维港池整体物理模型试验在防波堤稳定性、越浪量和优化设计方面的必要性。     

装配式码头灌浆连接节点压弯性能试验研究

对3组装配式码头灌浆连接节点试件进行压弯试验,研究不同灌浆长度和灌浆厚度下灌浆节点的压弯承载力、延性和破坏模式。结果表明,灌浆节点试件具有较好的延性和较高的承载力,灌浆节点受压弯荷载的破坏模式为钢管的压屈破坏;压弯构件的极限承载力随着灌浆长度的增大而增大;灌浆厚度的变化对构件的承载力影响不大,但灌浆厚度增大可以提高灌浆体底部的抗裂能力,建议实际应用时适当增大灌浆厚度。     

铁路路基动态变形模量的数值模拟分析

介绍铁路路基动态变形模量理论计算公式的推导及动态变形模量的测试原理,采用有限元软件模拟动态变形模量的测试过程,分析承载板与土体接触压力、路基动态变形模量的影响因素,并计算动态变形模量的有效测试深度.结果表明:在承载板中心一定范围内,接触压力模拟结果较理论计算值大;土体的动弹性模量对接触压力影响很小,可以忽略;路基动态变形模量测试冲击荷载作用下,土体只发生弹性变形;动态变形模量与土体动弹性模量呈线性关系,路基动态变形模量的模拟结果大于理论计算值;土体的泊松比对动态变形模量影响较小;动态变形模量有效测试深度建议取0.5~0.6 m.     

单叶片螺旋钢桩竖向承载特性数值分析

为分析单叶片螺旋钢桩在砂土地层竖向抗压承载特征,结合单叶片螺旋钢桩现场静载试验进行有限元软件模拟。将数值计算结果与现场实测数据进行对比分析,验证其数值计算结果的可靠性,其次采用该有限元软件分别模拟不同相对密实度砂土中几何参数不同的单叶片螺旋钢桩静载试验而得到不同荷载-位移曲线,同时将螺旋叶片直径的5%位移值对应荷载作为桩极限承载力。考虑砂土相对密实度,钢桩埋深,螺旋叶片直径,中心钢轴4个参数变化对单叶片螺旋钢桩极限承载力影响。结果表明:单叶片螺旋钢桩桩周土层的相对密实度和桩埋深是影响承载力的主要参数,螺旋钢桩叶片直径影响次之,钢轴直径的影响最小;同时,单叶片螺旋钢桩极限承载力增量百分比在松砂中最大,中密砂次之,密砂最小。     

钢护筒与钢筋混凝土协同受力机理数值分析与模型验证

以果园二期桩基为原型,对6个钢护筒与钢筋混凝土短柱结构和2个钢管混凝土短柱进行轴压试验。基于ABAQUS有限元软件,以钢护筒厚度、配筋率、配箍率为参数进行分析。结果表明,钢护筒与钢筋混凝土短柱结构中,钢护筒与箍筋对核心混凝土均有约束作用,且双重约束效应明显,有效抑制混凝土裂缝开展,使结构具有更高的承载力、塑性和韧性。箍筋对混凝土的约束作用对钢护筒与钢筋混凝土短柱的承载力、塑性及延性性能影响显著,随着箍筋间距的减小,构件的承载力及延性性能有明显提高。     

STX1(2)型驮背多功能运输车超偏载检测标准

分析了STX₁₍₂)型驮背多功能运输车对既有超偏载检测方法和标准的适应性,提出了该车的超偏载检测方案,明确了公路货车或半挂车超偏载的检测方法及评判标准。     

高速铁路深厚软土地基物理力学特性分析及沉降控制

为研究东北地区高速铁路软土地基路基物理力学特性及其沉降控制方法,通过物性参数试验、无侧限抗压强度试验、直接剪切试验以及固结试验等,并结合工后沉降检算,提出适用于该片区的地基加固手段。研究表明:(1)研究区域软弱夹层分布在地表8 m以下,厚度为4~8 m,液性指数随深度逐渐下降,在14 m处降至最低;(2)0~8 m深度范围内,无侧限抗压强度、黏聚力、内摩擦角、压缩模量等指标随深度变大逐渐下降,深度8 m以下,强度指标随深度加深不断上升,在14 m深度处达到峰值;(3)桩长为8~16 m时,工后沉降随着CFG桩长增大线性降低,桩长增至16 m时,工后沉降降幅约为70%,为该区域最优桩长。     

Structural safety assessment procedure for membrane-type LNG CCS considering hydroelasticity effect

As environmental regulations have become more onerous, the demand for LNG and LNG carriers has increased. The LNG cargo containment system (LNG CCS) is one of the most important facilities in LNG carriers, and many membrane types of LNG CCS have been developed so far. Traditionally, sloshing model tests are performed and a series of statistical approaches are used to obtain design sloshing pressures. Then, these design loads are utilized to analyze the structural safety of LNG CCS. In the sloshing model test, the flat and almost rigid plate is used as the LNG CCS instead of a real model, and thus, the hydroelasticity effect cannot be considered. In the present research, the effect of hydroelasticity on sloshing pressure was investigated in a fluid-structure interaction simulation. A wet drop simulation was conducted, and its results subsequently were compared with wet drop experimental test results to ensure their validity. Then, two types of structure model, namely a flat-rigid plate model and a flat-flexible CCS model, were generated to investigate the effect of hydroelasticity. Also, a fluid hitting analysis model was devised to realize the sloshing phenomenon, and the two generated structure models were applied as the structure domain in the analysis. In the fluid hitting simulations, it was found that the hydroelasticity effect on sloshing pressure is significant. Thus, correction factors, which are quantitative values of the effect of hydroelasticity, were derived (and are proposed herein). Finally, a structural safety assessment procedure for consideration of the hydroelasticity effect was derived (and is suggested herein).     

Numerical modelling of hydrodynamic responses of Ocean Farm 1 in waves and current and validation against model test measurements

With the continuous growing of the aquaculture industry and increasingly limited fish farming sites at close to shore areas both in Norway and worldwide, there is a need to develop fish farms suitable for aquaculture production in typical offshore environments. For this purpose, SALMAR has developed and deployed the Ocean Farm 1 facility for offshore fish farming.The main purpose of this paper is to develop a reliable numerical model and investigate the motion responses of the Ocean Farm 1 structure in waves and current. The established numerical model consists of the Ocean Farm 1's frame structure (with rigidly-connected circular column components), the net and the mooring system. The hydrodynamic external loads and coefficients of the frame structure are obtained by using potential flow theory. The quadratic drag load on the individual circular columns of the frame structure is formulated by a given drag coefficient. The loads on the net are formulated by using the screen model, where the Reynold number dependent lift and drag forces are formulated as a function of the solidity ratio Sn of the net, relative inflow angle and velocity. The hydrodynamic loads on the mooring lines are formulated using the Morison's equation and the structural responses of the mooring lines are obtained using a nonlinear FE model.With the developed numerical model, time domain simulations are performed. The simulation results are firstly validated against measured data from the decay tests, current tests, and regular wave tests. After the validation, numerical simulations are performed in different irregular wave and current combined weather conditions and the obtained motion response of Ocean Farm 1 are discussed and compared with available measurement data.     

隧道内列车振动对近接建筑物的影响分析北大核心

针对运营列车通过隧道时引起近接建筑物地面振动进行了现场测试,并对测试数据进行了功率谱、Z振级及1/3倍频程分析。在此基础上,利用有限元软件建立了围岩-隧道-轨道结构振动模型,对运营列车引起的建筑物振动进行了计算分析。结合实测与计算结果,对近接建筑物的振动特性进行了评价。结果表明:列车以速度300 km/h通过隧道时,地面振动功率谱主频白天集中在33.0 Hz左右,夜间集中在42.7 Hz左右,夜间的主频比白天大;地面各测点处Z振级的总体趋势是先波动式上升,再平缓波动,后逐渐波动式下降,地面Z振级主要集中在20~80 dB;1/3倍频程分频最大振级白天位于48.4~60.8 dB,夜间位于47.4~59.4 dB;列车通过隧道时基础处振动速度峰值整体呈波浪形分布,引起的地面振动速度小于0.045 mm/s,小于规范限值要求,对建筑物基础以及人体舒适度的影响较小;在缺乏大量实测结果的条件下,结合小样本实测结果,采用有限元计算结果进行振动响应评价具有一定的可行性。